Hub Nut Sockets

A specialised bi-hex deep socket that is commonly used on Ford Transit 130 | 150 | 190 vehicles (1993 onwards) and swing arm / axle nuts on Ducati / Augusta motorcycles.

• 56mm dia | 12 Point
• 3/4" Sq Drv

A thin wall hub nut socket designed to suit many applications, including 65mm Ford Transit rear hubs (before 1993).

• Size: 65mm (2-9/16") (Outside dia: 84mm)
• 6 point (single hex)
• 3/4" Sq Drv

A special 4 pin impact socket for removing the rear hub nut on RWD Ford Transit (>2014). The alignment shaft allows accurate location onto the castellated nut.

• 19mm hex drive
• 6.8mm stud width
• Outer rim: 69.5mm
• OEM Equiv: 205-1007

Specialised front hub nut socket for servicing the front hub lock nut on Toyota 2WD trucks (07-). The socket has 8 pins, and is designed for use with impact tools.

• 3/4" Sq Drv
• OEM Equiv: 09318-12010 8 Pin
• Applications: 4Runner (07-14) | Sequoia (08-14) | Tundra (07-14)

A specialised 6 point deep impact socket suitable for use on hub nuts on Peugeot vehicles.

• 40mm diameter | 6 Point
• Deep impact socket
• 1/2" Sq Drv

An extra long thin wall socket for deeply recessed hub nuts. Also suitable for adjusting the free play in wheel bearings on Landcruiser / Nissan Patrol.

This socket is turned by inserting a tommy bar or large screwdriver through the cross drilled holes at the opposite end to the hexagonal head.

• 54mm dia | 6 Pt
• 165mm depth | 180mm OL
• Applications: Landcruiser 40/60/70/80/100 Series | Nissan Patrol Y60/GQ/MQ/MK.
• 1/2" Sq Drv

Wheel bearing locknut socket for front wheel adjusting nuts on Landcruiser 40 | 60 | 70 | 80 | 100 Series

• 55mm | 6 Point hex
• 85mm depth
• Thin wall
• 1/2" Sq Drv

A specialised locknut socket for the removal / installation of wheel bearing lock nuts. Thin wall design / extra deep clearance to suit most applications.

• 2-3/32" | 53mm diameter
• 6 point

Part of the Endeavour specialist impact socket range. This 6 point socket has specific application for use with most Land Rover vehicles.

• 52mm diameter
• 6 point impact socket
• 46mm depth
• 1/2" Sq Drv

A specialised 6 pin socket for servicing rear axle hubs on twin wheel Mercedes / VW commercial vehicles.

• Applications: Mercedes Sprinter | Nissan Interstar | VW Crafter / LT | Renault Master
• OD: 74mm
• 3/4" Sq Drv

A specialised 6 pin socket for servicing rear axles on Mercedes Sprinter single axle vehicles.

• Application: Mercedes Sprinter (single axle)
• 60.5mm ID | 69m OD | 6 Pin

This deep 12 point impact socket has specific application for removing hub nuts used across the VAG range on gearbox drive flanges, hub nuts etc.

• 24mm diameter | 12 Point
• 1/2" Sq Drv
• 90mm overall length