Steering

A specialised kit for removing / installing seized output CV shafts in wheel hubs. This kit suits manhy BMW vehicles, but not the E53 X5. For this vehicle, refer ET1253D.

• Applications: E30 | E31 | E32 | E36 | E39 | E46 | E52 | E53 | E60 | E63 | E64 | E65 | E66 | E67 | E83 | E85 | RR1

A time saving tool for removal and reinstallation of the caster arm (thrust arm) bushing mounts on BMW 3 Series vehicles.

• Models: E30 | E36 | E46

For removing and installing bushes and bearings. The hydraulic cylinder helps save time and energy compared to manual methods.

Universal application.

• Includes M20 x P2.5 spindle
• Sleeve sizes: 18-60mm ID / 26-68mm OD, with 2mm increments

A time saving tool which allows bush replacement to be done on vehicle without having to remove the lower control arm This kit removes / installs the front lower control arm bushes on the W170 | W202 models.

Bush replacement can be done on car without having to remove the lower control arm, allowing the job to be performed in about an hour.

Services inner tie rods that use flats - not hex inner nut

• Applications: 30 - 48mm
• Length: 406mm

A specialised kit for spreading the steering knuckle to enable the removal / installation of shock absorbers without the risk of damaging the aluminium or cast iron knuckle.

The tool is adjustable and suitable for steering knuckles with either a clamping style strut or ball joint mount.

Universal application.

A specialised kit for spreading the steering knuckle to enable the removal / installation of shock absorbers without the risk of damaging the aluminium or cast iron knuckle.

The tool is adjustable and suitable for steering knuckles with either a centralised slot or a non centralised slot.

Specially design for twin ball joints as fitted to Audi | VW control arms.

Heavy duty steering wheel puller kit. The two yoke design suits most steering wheels. Supplied with a range of bolts.

• 2 yoke design
• 1/4" | 5/16" | M8 bolts