Oscilloscopes

AutoSim allows a mechanic to simulate the replacement of a sensor.

Simulating output signals of most automotive sensors, AutoSim picks up service issues where a scan tool's diagnosis ends. Sensors tell the on-board computer when something is wrong. AutoSim helps determine if the cause is a faulty sensor, wiring or the ECU.

The product is mainly used for wiring tests. This is because the device can simulate the voltages and check the live data readings on the scan tool to confirm the wiring. You can simulate most sensors from ABS to O2 sensors. Eliminates need to replace non-defective sensors; by the time you have changed a couple of un-needed sensors the device has paid for itself!

• Voltage simulation range: 0.1V ~ 12V
• Frequency simulation range: 0.1Hz ~ 10KHz
• Trigger pulse output: up to 0.15 amperes maximum
• Output amplitude: 0.2V to 12V output amplitude can be selected at each mode

A fast / accurate method to diagnose engine problems. Verify the mechanical condition of the engine before using a scan tool. All engines generate pulsating pressure waves. This sensor allows you to display "engine pulses" on standard oscilloscopes. By using the first cylinder for sychronisation, a faulty cylinder can be determined. Engine problems will always cause a fluctuation of the waveform.

• Use with any standard oscilloscope
• Detect valve leakage, timing issues, bad injectors without major disassembly
• PC connectivity via USB port
• Save waveforms as BMPs

A unique two channel automotive testing scope in a standalone tablet. Designed specifically for automotive use, it has a range of guided tests (with extensive context sensitive help menus). Purpose built for component testing. Much easier to use / more auto functionality than standard oscilloscopes.

ADVANCED KIT

• Tests most engine sensors
• Tests actuators / solenoids
• Advanced ignition measurement
• Test batteries, alternators, starters
• Test starter / charging circuits
• Observe fuel injector / pump signals
• View CAN bus signals
• Measure high / low currents
• 2 channel - 2 x 20 MS/s ADCs
• 7" TFT Colour display
• Rechargeable battery
• PC connectivity via USB port
• Save waveforms as BMPs
• Guided tests with help menus
• Includes first view sensor
• Easier to use than most scopes

Two channel scope in a standalone tablet. Designed SPECIFICALLY for automotive use, it has a range of guided tests (with extensive context sensitive help menus). Purpose built for component testing. Much easier to use / more auto functionality than standard oscilloscopes.

• Tests most engine sensors
• Tests actuators / solenoids
• Advanced ignition measurement
• Test batteries, alternators, starters
• Test starter / charging circuits
• Observe fuel injector / pump signals
• View CAN bus signals
• Measure high / low currents
• 2 channel - 2 x 20 MS/s ADCs
• 7” TFT Colour display
• Rechargeable battery
• PC connectivity via USB port
• Save waveforms as BMPs