A short series single hex oxygen sensor socket for the removal / installation of Oxygen / Lambda sensors. Designed with a slot in the side to allow it to be fitted over the wiring harness.

• Applications: Jeep Grand Cherokee 3.0L V6 diesel (from 2014) | Dodge RAM 1500 3.0L V6 Diesel (from 2014)
• Overall length - 70mm
• 24 mm diameter | 6Pt
• 1/2" Sq Drv (or can also be driven with a 30mm wrench

These short series taps are designed to restore exhaust sensor port threads before installing new NOx sensors.

• Applications include: Ford EcoBlue | Mercedes
• M20 x 1.5 | M22 x 1.5 threads
• 48mm overall length
• Made from Titanium coated Chrome Moly
• Use with axle grease to catch any removed metal in the threads.

Cut out in socket allows the wires to the sensors to be bypassed. Wire range of applications including Holden, Mitsubishi, Nissan and VAG vehicles.

• 7/8" (22mm) dia | 7mm slot
• 80mm OL
• 3/8" Sq Drv

This thread chaser is designed to clean and repair damaged oxygen sensor port threads.

This thread chaser can also be used on 12mm spark plugs. Always use ANTI-SEIZE.

• M12 x 1.25 thread

Specialised socket with slot that allows the sensor wires to be bypassed. Applications include Holden, Mitsubishi, Nissan and VAG group vehicles.

For heated and non heated Lambda sensors.

• 22mm dia
• 90mm overall length
• 3/8" Sq Drv

A specialised socket for removing oxygen sensors. This socket is offset, only 31mm high / 57mm long making it ideal to use in those harder to reach areas.

• 22mm diameter
• 31mm high
• 3/8" Sq Drv