A specialised tool for quickly / safely installing rear oil seals on Isuzu trucks with 4JJ1 engines. An essential tool to avoid damaging oil seals during installation.

This tool is designed to suit a wide range of late model Isuzu vehicles with 4JJ1 engines. For earlier model vehicles, refer ET1261A.

• Genuine oil seals: 8-97071-561-1 | BZ4962E
• Applications: 3.5T 4JB1 | 4JG2 | 4JH1 | 4JJ1 130HP / 150HP
• Chassis: NKR69 (4JG2) (94-) | NKR77 (4JH1-TC (02-) | NLR85 (4JJ1-TCS) (08-) | NNR85 (4JJ1-TCS) (08-)

Save time, avoid costly component replacement, and restore damaged NOx sensor threads with the Endeavour ET2218 NOx Sensor Tap Set. Designed specifically for servicing NOx sensor ports in modern exhaust after-treatment systems, this specialist kit allows technicians to clean and repair damaged threads, helping ensure correct sensor installation and accurate emissions system operation.

This kit provides the correct taps to restore thread integrity quickly and professionally, reducing downtime and helping avoid expensive repairs.

• Applications include: Ford EcoBlue | Mercedes
• M20 x 1.5 | M22 x 1.5 threads
• 48mm overall length
• Made from Titanium coated Chrome Moly
• Use with axle grease to catch any removed metal in the threads.

This thread chaser is designed to clean and repair damaged oxygen sensor port threads.

This thread chaser can also be used on 12mm spark plugs. Always use ANTI-SEIZE.

• M12 x 1.25 thread

This thread chaser is designed to clean and repair damaged oxygen sensor port threads.

This thread chaser can also be used on 18mm spark plugs. Always use ANTI-SEIZE.

• M18 x 1.50 thread
• Use with 21mm socket

Specialised socket with slot that allows the sensor wires to be bypassed. Applications include Holden, Mitsubishi, Nissan and VAG group vehicles.

For heated and non heated Lambda sensors.

• 22mm dia
• 90mm overall length
• 3/8" Sq Drv

A short series single hex oxygen sensor socket for the removal / installation of Oxygen / Lambda sensors. Designed with a slot in the side to allow it to be fitted over the wiring harness.

• Applications: Jeep Grand Cherokee 3.0L V6 diesel (from 2014) | Dodge RAM 1500 3.0L V6 Diesel (from 2014)
• Overall length - 70mm
• 24 mm diameter | 6Pt
• 1/2" Sq Drv (or can also be driven with a 30mm wrench

A specialised Lambda socket for shrouded sensors on Ford Fiesta 1.2L (08 - 16). Thin wall design / cut out slot allow access to the sensor which is otherwise difficult to access due to the tight fitting heat shield.

• Thin wall
• 22mm x 119mm
• 1/2" Sq Drv