Perfect for connecting to fuel injectors, MAP and TPS sensors, as well as any weather pack seal type connectors. The modular design is compatible with any industry-standard, 4mm plug whether shrouded or not. All probes are supplied in a protective plastic tube.

• 4 colours | 0.7mm (0.028") OD back probe pins
• Made in UK quality
• 1000V CAT III 20A

A versatile heavy duty long handled riveter, suitable for alloy and stainless steel rivets - blind rivets / female nutcerts / male nutcerts.

• Stainless Rivets: To 6.4mm
• Nutcerts: To 12mm
• RivBolts: To 8mm

Narrow 5.5mm camera for engine access.

Connects to your phone / tablet by wifi allowing results to be viewed clearly / easily saved.

• 1.5m gooseneck cable
• 1280 x 720px resolution
• Rechargeable battery

An essential safety tool. Locks onto gas struts during vehicle service, to enable the struts to be fixed in an extended position. Universal application for all gas struts on boots, bonnets, hatch backs etc, as the clamp simply locks onto the strut's shaft.

• Aluminium body and brass tip to prevent damage to the lift support
• Magnet to hold the tool in place while securing the clamp
• For up to 13mm struts

This brake bleeder adaptor has been designed to allow pressure brake bleeding on the Ford Ranger from 2012 onwards. This cap screws directly onto the master brake cylinder.

• Suits Ford Ranger (2012 onwards) vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 41mm diameter

An individual master cylinder adaptor for use with standard pressure brake bleeders, including the ETWH505H. This adaptor is designed to connect to the master cylinder reservoir to allow replacement brake fluid to be pushed through the system.This adaptor suits Colorado / Isuzu D-Max vehicles.

• Suits Colorado / Isuzu D-Max vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 54mm diameter

An individual master cylinder adaptor for use with standard pressure brake bleeders, including the ETWH505H. This adaptor is designed to connect to the master cylinder reservoir to allow replacement brake fluid to be pushed through the system.This adaptor suits Honda vehicles.

• Suits Honda vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 74mm dia

An individual master cylinder adaptor for use with standard pressure brake bleeders, including the ETWH505H. This adaptor is designed to connect to the master cylinder reservoir to allow replacement brake fluid to be pushed through the system.This adaptor suits Mitsubishi vehicles.

• Suits Mitsubishi vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 34 mm dia

An individual master cylinder adaptor for use with standard pressure brake bleeders, including the ETWH505H. This adaptor is designed to connect to the master cylinder reservoir to allow replacement brake fluid to be pushed through the system.This adaptor suits Mitsubishi vehicles.

• Suits Mitsubishi vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 35.5mm dia

An individual master cylinder adaptor for use with standard pressure brake bleeders, including the ETWH505H. This adaptor is designed to connect to the master cylinder reservoir to allow replacement brake fluid to be pushed through the system.This adaptor suits Toyota vehicles.

• Suits Toyota vehicles.
• Nitto style connector fitting
• Zinc alloy construction
• 23mm dia