Essential workshop tools for removing / fitting interior and exterior trim clips. Made from durable nylon to reduce risk of damage to dashboards, door panels, mouldings, trims etc

• Remove upholstery, trim, trim studs etc
• Angle | straight | wide | narrow | forked | tapered applications
• Impact resistant high quality nylon

Fuel Filter Remover designed specifically for the 2.0 Diesel variants of GWM and Haval vehicles.

• Engine code: GW4D20
• Application: GWM Cannon 2.0L Turbo Diesel
• For OEM filter: 1111402XED95

A specially designed wrench to install / remove coolant caps on Audi vehicles which have a locking mechanism.

This wrench is fitted with a tooth which depresses the cap release mechanism when pressure is applied.

• Fits Audi cap # 4MO-121-321-Q
• 3/8" Sq Drv
• Do not release the cap when the cooling system is under pressure and / or hot

• Suits most E60-E93 | F01-F86 vehicles
• 87mm (across flats) | 6 Indents
• 3/8" Sq Drv

Removes lock nuts on thermo viscous fans found on BMW | Ford (and other vehicles). Made from tempered pressed steel with PVC dipped handle.

• 32mm
• Straight design
• 380mm overall length

Specially designed slots fit over and grip firmly on three of the studs holding the viscous fan clutch assembly, to allow the release of the locking nut.

• Applications: Ford Falcon | Fairline, and many other vehicles.
• Length: 450mm (17-3/4")

This set comprises a special clutch holder and nut wrench for replacing the water pump in Ford vehicles.

• 1-7/16" | 2-5/16" jaw openings

A specialised wrench set for fan clutch removal and replacement on Ford vehicles. Two hub wrenches (32mm & 36mm) and one special holding bar to fit fan clutches.

• Straight wrenches | 385mm (15-1/4") length
• 32mm | 36m jaw openings
• Ford fan clutch holder (DA3387)