The Sonsbeek truck tyre inflator is designed to reliably inflate truck tyres up to 220 PSI. The inflator has a large 90mm dial gauge for easy reading. The unit is designed for inflation, deflation and measurement.

The inflator is designed for rugged applications, and is supplied with a rubber impact protector on the gauge, rubber grip on the chuck, and a pressed steel lever.

One button operation

• 90mm dial for easy reading
• 220 PSI scale
• 1m hose length
• Rubber gauge protector

The ET5678 Coolant Conductivity Tester is a compact, easy-to-use tool designed to quickly assess the electrical conductivity of coolant.

Many EV / hybrid vehicles use a special antifreeze that is not diluted and is manufactured to have very low conductivity. This tester allows users to check conductivity, to ensure that the coolant has not been diluted with water, which is a major safety issue.

• Conductivity & total dissolved solids (TDS) meter - 0 to 9990uS | 0.0 to 19.9ppt.
• Resolution: Electrical conductivity: 1uS(<1999uS); 10uS(>1999uS)/0.01mS. TDS: 0.1PPT. Temp: 0.1 .
• Accuracy: Electrical conductivity: ±2% | TDS: ±2%F.S.Temp: ±0.5
• 2x 1.5V AAA batteries (included)

A specially designed wrench to install / remove coolant caps on Audi vehicles which have a locking mechanism.

This wrench is fitted with a tooth which depresses the cap release mechanism when pressure is applied.

• Fits Audi cap # 4MO-121-321-Q
• 3/8" Sq Drv
• Do not release the cap when the cooling system is under pressure and / or hot

• Suits most E60-E93 | F01-F86 vehicles
• 87mm (across flats) | 6 Indents
• 3/8" Sq Drv

Removes lock nuts on thermo viscous fans found on BMW | Ford (and other vehicles). Made from tempered pressed steel with PVC dipped handle.

• 32mm
• Straight design
• 380mm overall length

This wrench is designed to help remove the coolant cap in vehicles where the coolant tank is positioned under the bulkhead making hand removal difficult.

• 60mm (across flats) | 6 indents
• 3/8" Sq Drv

Specially designed slots fit over and grip firmly on three of the studs holding the viscous fan clutch assembly, to allow the release of the locking nut.

• Applications: Ford Falcon | Fairline, and many other vehicles.
• Length: 450mm (17-3/4")

A specialised wrench set for fan clutch removal and replacement on Ford vehicles. Two hub wrenches (32mm & 36mm) and one special holding bar to fit fan clutches.

• Straight wrenches | 385mm (15-1/4") length
• 32mm | 36m jaw openings
• Ford fan clutch holder (DA3387)