Sonsbeek non sealing type tyre chucks are designed to be used when the chuck is to be connected to a tyre inflator / gauged airline.

Our non sealing type chucks will not seal the chuck opening when not in use. When pressurised, it will open the tyre valve core, allowing air from the hose to be transferred to the tyre.

Sonsbeek non sealing type chucks are available in a range of different configurations. Where the chuck is to be connected directly to an airline, a sealing type chuck should be used.

• Dual angle chuck connector
• 1/4" NPT female inlet
• Non Sealing type

• SPREAD: 80mm
• REACH: 90mm
• CAPACITY: 1.1 tonnes

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 150mm
• Reach: 150mm
• Capacity: 1.1 tonnes

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 15 - 200mm
• Reach: 200mm
• Capacity: 1.17 tonnes

Hardened drop forged alloy steel jaws for pulling internal bearing caps, seals bushings. A cone holds the jaws in place during pulling. Use with a 5/8-18 slide hammer.

• 5/16" - 3-1/4" spread
• 3-1/2" reach

For balancer, pulley, gear & flywheel. Drop forged 4-slot yoke and a variety of cap bolts and forcing screw tips make this set universal.

• Includes 5/16" | 3/8" | M8 bolts.
• Do NOT use with impact wrenches.

A heavy duty mechanical / hydraulic hub puller kit for various stud patterns up to five studs. The individual legs, on a raised yoke assembly, allows for quick attachment to vehicle hubs.

Suitable for removing wheel hubs mounted on tapered axles, as well as press fit rear brake drums.

• Includes heavy duty striking handle
• 190mm reach
• 10 Tonne hydraulic ram