The AutoSim Pro Master Kit is a professional-grade automotive sensor simulator and signal generator, designed to streamline diagnostics and fault analysis across a wide range of vehicle systems. Whether you're working on cars or trucks, this handheld device replicates real-world sensor and actuator signals, allowing technicians to test wiring, ECUs, and components without unnecessary replacements.

Detect whether the ECU, a feed, plug in connection, or sensor is defective. Eliminate faults without simply replacing parts on suspicion only.

Key features:

• Signal Simulation: Generates voltage, frequency, PWM, and O sensor signals to mimic real sensor behavior.
• Waveform Variety: Supports sine, square, triangular, and ramp signals with adjustable frequency and amplitude.
• Actuator Activation: Drives actuators with up to 4A continuous current, simulating real operating conditions.
• Precision Control: Offers fine-tuned output settings with 0.1% duty cycle accuracy and 10mV voltage steps.
• User-Friendly Interface: Illuminated 2.4" TFT LCD display and intuitive function keys for quick setup and operation.
• Robust Protection: Includes reverse polarity, over-voltage, thermal shutdown, and short-circuit safeguard.

CONTAINS ET0098PRO PLUS:

• Insulated crocodile clips (Red & Black)
• Back Probe set (5 needles)
• Crocodile Clip 25A, Red & Black
• Crocodile Clip 15 A, Blue
• Pluggable Terminal Block (2-Pin, 5mm)

This inductive clamp is designed to clip onto the spark plug wire to cylinder one to get the trigger signal that is used to identify the correct cylinder number of each ignition voltage signal.

A specialised current clamp to allow your oscilloscope, multimeter to measure electrical current from 10mA up to 60A - both AC / DC - with a frequency response up to 20kHz.

This current clamp adaptor is ideal for displaying current waveforms for fuel injectors, fuel pumps, ignition coil circuits, and testing the solenoid valve for electronic diesel fuel injection control (EDC) systems.

The small measuring jaws allow the adaptor to be used in tight spaces.

• 4mm banana plug connectors
• Two calibration settings: 10mA - 20A AC / DC range & 20A - 60A AC / DC range
• 9mm max jaw opening
• 9V DC battery supplied with unit

Adds a Pressure Pulse sensor for engine health testing, 2x AC/DC clamp meters for current testing and doubles the ignition testing components to fully utilise both channels on the scope.

Ditex heavy duty oscilloscope automotive test leads are made with silicon insulated leads and nickel plated gripping surfaces for optimum electrical performance. The oscilloscope test leads are available with BNC plugs to connect to your automotive diagnostic equipment.

• 150 Strands of Copper Wire
• Super Flexible Silicone Cover, 18 AWG (0.75 mm2)
• Jacket special silicone rubber (non-sticking treatment) with 2.3mm outer diameter of silicon jacket
• 2m (7 feet) total length (1.5m coaxial cable and 0.5m silicon wire)
• Long cable life assured by the soft molded strain reliefs at all stress points
• Wide operating temperature range: -65 ¡C to +150 ¡C
• Alligator type clip ground lead, and an active test lead with high quality 4 mm banana plug

A comphrehensive kit containing the I-Tester plus all necessary accesories to test:

- Relative compression via Current or Volts

- Synced compression test (allows you to know which cylinder(s) is low on compression.)

- Actual common rail fuel pressure sensor readings.

Kit includes:

• ET0090 I-Tester
• Inductive pick up clamp
• OBDII compression test adaptor
• 10:1 Voltage attenuator
• Back probe needles
• Alligator clips