A specialised current clamp to allow your oscilloscope, multimeter to measure electrical current from 10mA up to 60A - both AC / DC - with a frequency response up to 20kHz.
This current clamp adaptor is ideal for displaying current waveforms for fuel injectors, fuel pumps, ignition coil circuits, and testing the solenoid valve for electronic diesel fuel injection control (EDC) systems.
The small measuring jaws allow the adaptor to be used in tight spaces.
- 4mm banana plug connectors
- Two calibration settings: 10mA - 20A AC / DC range & 20A - 60A AC / DC range
- 9mm max jaw opening
- 9V DC battery supplied with unit
| SKU | ET0102-02 |
| Barcode # | 9321280409194 |
| Brand | CarScope |
| Product weight | 0.3300kg |
| Shipping weight | 0.330000kg |
12 Months
Others also bought
Kabo Ratchet Bit Holder
A high quality, light weight aluminium ratchet handle with double flexible joints. A really handy tool for all mechanics.
- Includes 19 popular bits & 1/4" square drive adaptor.
More from this category
CarScope #1 Cylinder Pick Up Clamp
This inductive clamp is designed to clip onto the spark plug wire to cylinder one to get the trigger signal that is used to identify the correct cylinder number of each ignition voltage signal.
CarScope 600A AC / DC Current Clamp
This clamp adaptor is a transducer which will allow your oscilloscope, motor tester or multimeter to measure electrical current up to 600 amperes, both types AC or DC, with a frequency response up to 400 Hz.
When measuring current with this clamp adapter, there is no need to break into the circuit or disturb the isolation as the opening jaws simply clamp around the current carrying conductor. No electrical contact is required.
- 30mm jaw opening
- 0 - 600A range (AC / DC)
- 0-600mV output (AC / DC)
- Supplied with 4mm banana plug type connectors. A separate BNC to 4mm adaptor may be required for some applications.
CarScope Advanced Accessory Kit
Adds a Pressure Pulse sensor for engine health testing, 2x AC/DC clamp meters for current testing and doubles the ignition testing components to fully utilise both channels on the scope.
CarScope BNC to Banana Probe
Ditex heavy duty oscilloscope automotive test leads are made with silicon insulated leads and nickel plated gripping surfaces for optimum electrical performance. The oscilloscope test leads are available with BNC plugs to connect to your automotive diagnostic equipment.
- 150 Strands of Copper Wire
- Super Flexible Silicone Cover, 18 AWG (0.75 mm2)
- Jacket special silicone rubber (non-sticking treatment) with 2.3mm outer diameter of silicon jacket
- 2m (7 feet) total length (1.5m coaxial cable and 0.5m silicon wire)
- Long cable life assured by the soft molded strain reliefs at all stress points
- Wide operating temperature range: -65 ¡C to +150 ¡C
- Alligator type clip ground lead, and an active test lead with high quality 4 mm banana plug
Carscope i-Tester Master Kit
A comphrehensive kit containing the I-Tester plus all necessary accesories to test:
- Relative compression via Current or Volts
- Synced compression test (allows you to know which cylinder(s) is low on compression.)
- Actual common rail fuel pressure sensor readings.
Kit includes:
- ET0090 I-Tester
- Inductive pick up clamp
- OBDII compression test adaptor
- 10:1 Voltage attenuator
- Back probe needles
- Alligator clips