The Power Probe 4 is a multi-use Circuit Tester with built-in diagnostic power.

This tool simplifies the testing of fuse boxes, verifies correct operation of motors, lights, relays, sensors, wires, communications circuits and computer drivers. The large LCD colour display makes viewing live test information and mode selection simplified in even direct sunlight or complete darkness.

• Supplies Power and Ground
• Digital voltmeter with Min/Max voltage capturing
• 20 ft power lead
• Tests for bad grounds / short circuits
• Powered by vehicle battery
• Gold plated brass probe tip
• Directed LED head lamps to illuminate test area
• Ohmeter / Frequency
• Pulse width (+tive & -tive)

Additional diagnostic modes:

• Petrol fuel injection tester
• PCM / ECM driver tester
• Signal tracer (use with ECT3000)

All-in-one driver box to test all petrol injectors including the latest GDI Piezo injectors. Plus diesel injectors.

Ideal for bench testing injectors to see if they are opening correctly. Also use in conjunction with ultrasonic cleaners to better clean internal parts, or with injector nozzle tester to test spray pattern.

• Automatically detects injector type
• From 1Hz to 20Hz adjustable
• Supplied with 6 adaptors to connect to a fuel rail of a traditional petrol PFI injector tester
• Signal output cords for both petrol / diesel injectors
• Powered by 240V adaptor (not shown)

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 150mm
• Reach: 150mm
• Capacity: 1.1 tonnes

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 15 - 200mm
• Reach: 200mm
• Capacity: 1.17 tonnes

• SPREAD: 80mm
• REACH: 90mm
• CAPACITY: 1.1 tonnes

Hardened drop forged alloy steel jaws for pulling internal bearing caps, seals bushings. A cone holds the jaws in place during pulling. Use with a 5/8-18 slide hammer.

• 5/16" - 3-1/4" spread
• 3-1/2" reach

A specialised kit for extracting blind hole bearings. This kit contains eight adaptors plus a slide hammer and two leg puller.

Please refer to the download link below for instruction manual / kit components.

For balancer, pulley, gear & flywheel. Drop forged 4-slot yoke and a variety of cap bolts and forcing screw tips make this set universal.

• Includes 5/16" | 3/8" | M8 bolts.
• Do NOT use with impact wrenches.