An essential set of 18 keys for draining sumps, axles, gearboxes, differentials etc. 3/8" Sq Drv.

• Hex: 8, 9, 10, 12, 14, 17mm
• Square: 7, 8, 10, 11, 12, 13, 14mm
• Square: 5/16" (male), 3/8" (male) | 10mm (female)
• Spline (Sec): M16
• Triangular: 10mm

A combination air / hand powered pump for quickly extracting brake fluid, coolant, engine oil, transmission fluid etc. Do not use to extract petrol.

An optional hose to bleed brakes (with brake nipple connector) - ET3586-BRAK is also available.

• Massive 10L capacity avoids the need to remove drain plugs etc
• Supplied with 4 suction tubes (6mm oil | 7mm oil | brake fluid connector | 10mm gear oil)

Engrave most materials with ease. A professional quality unit with steel housing.

• 13,000 blows / minute
• Hose length: 1.48m
• Air inlet: 1/4" NPT

• IEC 1010 rating: 1000V CATIII double / reinforced insulation 20A
• Threaded contact
• 1.2m double insulated silicone cable
• Bi coloured layers

This kit facilitates the replacement of the timing belt on the Chrysler DOHC common rail diesel engine fitted with / without balance shafts in the Voyager, Grand Voyager & LDV Maxus van by locking the crankshaft at TDC & camshafts in their timed positions.

• Engine codes: ENJ | ENR, SC28R150Q5 | SC25R136Q4
• Applications: Jeep Cherokee (01-08) | LDV T60 | V80
• For later model vehicles with a single camshaft sprocket, refer ET4370.

The ET6275 Survivor Socket is a universal emergency socket designed to grip and remove damaged nuts and bolts with ease. This 1/4 hex drv socket features a special locking design, allowing it to work with fastener profiles ranging from 9mm to 21mm.

Removes almost any type of wing nut, nuts, bolts including Spline, Torx¨, Hex etc.

• Not suitable for use with impact tools
• 1/4" hex drive
• 9-21mm

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 150mm
• Reach: 150mm
• Capacity: 1.1 tonnes

A special self gripping puller with slim legs. Able to be used with a slide hammer.

• Spread: 15 - 200mm
• Reach: 200mm
• Capacity: 1.17 tonnes

• SPREAD: 80mm
• REACH: 90mm
• CAPACITY: 1.1 tonnes

Hardened drop forged alloy steel jaws for pulling internal bearing caps, seals bushings. A cone holds the jaws in place during pulling. Use with a 5/8-18 slide hammer.

• 5/16" - 3-1/4" spread
• 3-1/2" reach

A specialised kit for extracting blind hole bearings. This kit contains eight adaptors plus a slide hammer and two leg puller.

Please refer to the download link below for instruction manual / kit components.

For balancer, pulley, gear & flywheel. Drop forged 4-slot yoke and a variety of cap bolts and forcing screw tips make this set universal.

• Includes 5/16" | 3/8" | M8 bolts.
• Do NOT use with impact wrenches.