Optional replacement hub grinder abrasive pad for the ET4070 hub grinder kit.

• 150mm outer dia
• 90mm inner dia

Replacement abrasive discs for the ET4074 hub cleaning kit.

• 5 pack

Ideal for quick cleaning / corrosion removal of car wheel hubs with stud bolts up to 40mm dia.

Replacememt abrasive discs available (ET4074-D).

• Use with cordless drill
• 3/8" Sq Drv adaptor included
• Max speeed: 1500 RPM

Optional replacement hub grinder abrasive pad for the ET4070 hub grinder kit.

• 150mm outer dia
• 90mm inner dia

Quickly removes corrosion / dirt. Quick change brushes suit both metric / imperial threads. Larger sizes suit commercial vehicles. Use by hand, or with cordless drill.

Wheel studs should be properly cleaned before refitting wheels / wheel nuts. A time saving solution to a common workshop task!

• Sizes: 12mm (7/16") | 13mm (1/2") | 14mm (9/16") | 16mm (5/8") | 22mm (7/8") | 28mm (1-1/8")
• 1/4" hex adaptor included, to use with air / electric drills.
• Cleaning brushes have a depth around 25 - 30mm.  Black hollow shaft has a further depth around 120mm.

A professional kit for removing stuck Bosch / Delphi / Mercedes CDI injectors. The kit is supplied with a slide hammer and a range of adaptors.

• M20 x M20 x 1.0 (Bosch) | M20 X M14 x 1.5 (Delphi)
• Mercedes CDI adaptor & M10 (with hole) insert tool for removing the internal part of Bosch injectors
• Slide hammer (5/8" UNF thread)

• Inhex (1.5 - 3mm) | SL: 3mm | PH#2)

An alternative seal set for the ET1797. These seals are made from NBR rubber which are suitable for most workshop fluids, but NOT brake fluid.

For brake fluid, use ET1797-EPDM.

• NBR seals for oil / similar fluids
• 2 piece set

A specialised set for removing PSA 2.0L | 2.2L HDi (DW10 | DW12) diesel fuel injectors (Bosch | Siemens). Allows the removal of seized injectors without the need to remove the cylinder head. Bridge fits onto the cylinder head allowing for safe removal of the injectors.

• Unscrew injector cap
• Extract internal sleeve from injector
• Thread force screw into injector
• Lower the bridge assembly over the force screw
• Screw down the force screw nut. Hold the force screw with a spanner

The next generation of Super screw cam clamps featuring innovative new safety features.

• Built in spring for extra clamping force on items being lifted.
• Visual clamping force indicator - lines align to indicate that the clamp is correctly tightened.

Super clamps are made in Japan for professional use. Screw cam clamps are ideal for lifting, turning, and pulling over.

• 2 Tonne capacity
• 0 - 40mm clamping range