An adaptor for use with the ET2512 trailer socket tester to test legacy 7 pin sockets.

• 13 pin >> 7 pin

Designed to be used with our ET2512 trailer tester, this 13-Pin Round to 7-Pin Flat Trailer Test Adaptor allows for testing of Australian style plugs. This adaptor converts a standard 13 pin round (European style) socket to a 7 pin flat (Australian style) plug, allowing seamless compatibility with a wide range of test equipment and trailers.

• Input: 13 pin round (vehicle side)
• Output: 7 pin flat (trailer side, Australian standard)
• Material: Impact resistant plastic housing with corrosion resistant terminals

Heavy vehicles require higher capacity smoke machines. The new SmokeMan HD delivers up to 120 PSI max pressure. Test more than just engines. Check for leaks on small water tanks etc...

However, please note that smoke (mineral oil and / or UV dyes) must not be injected into braking systems.

• Both flow and pressure control
• Up to 120 PSI max pressure (compressed air required)
• Heavy vehicle adaptor set included
• Dual gauges - Test and System Pressure
• 12 month warranty

Professional quality tester for late model trucks fitted with 7 pin type sockets. These testers are designed for testing the vehicle side socket, not the trailer itself.

There are 2 versions - for either 24N / 24S sockets.

• CANbus compatible.
• 4m cable to allow the unit to be used in the cabin.

Professional quality tester for late model trucks fitted with 7 pin type sockets. These testers are designed for testing the vehicle side socket, not the trailer itself.

There are 2 versions - for either 24N / 24S sockets.

• CANbus compatible.
• 4m cable to allow the unit to be used in the cabin.

The Power Probe Digital Clamp Meter is an 80 Amp, auto-ranging clamp meter designed specifically for the automotive technician. This meter is rated CAT III 600V and can measure Volts, Amps, Ohms, Frequency and Temperature, necessary for automotive electrical testing. This meter's diagnostic applications include (but are not limited to) Parasitic Draw, Crank Current testing and HVAC Temperature testing.

Supplied with 3x AAA batteries.

• Voltage: AC 600V | DC 600V
• Current: AC 80A | DC 80A
• Display 4000 counts
• Jaw Opening 24mm/0.9"
• Auto & Manual Ranging
• Auto Power Off / Non-Contact Voltage Detector
• Diode Open Voltage 3.2V
• Continuity Buzzer <50
• Data Hold
• Large LCD Display Backlight
• Work Light
• Low Battery Display

Designed to be used with our ET2512 trailer tester, this 13-Pin Round to 7-Pin Flat Trailer Test Adaptor allows for testing of Australian style plugs. This adaptor converts a standard 13 pin round (European style) socket to a 7 pin flat (Australian style) plug, allowing seamless compatibility with a wide range of test equipment and trailers.

• Input: 13 pin round (vehicle side)
• Output: 7 pin flat (trailer side, Australian standard)
• Material: Impact resistant plastic housing with corrosion resistant terminals

An adaptor for use with the ET2512 trailer socket tester to test legacy 7 pin sockets.

• 13 pin >> 7 pin

Professional quality tester for late model trucks fitted with 7 pin type sockets. These testers are designed for testing the vehicle side socket, not the trailer itself.

There are 2 versions - for either 24N / 24S sockets.

• CANbus compatible.
• 4m cable to allow the unit to be used in the cabin.

Professional quality tester for late model trucks fitted with 7 pin type sockets. These testers are designed for testing the vehicle side socket, not the trailer itself.

There are 2 versions - for either 24N / 24S sockets.

• CANbus compatible.
• 4m cable to allow the unit to be used in the cabin.