This kit helps clean / decarbonise the injector hole. Plus the seat cutters clean the bottom of the injector hole to allow proper setting of the new copper washer.

Helps avoid blow back due to poorly seated injectors.

• 3 seat cutters: 17mm flat | 17mm angled | 21mm angled
• Includes washer removal tool, injector blanking plugs (stop debris entering cylinders), wire brush cleaning set for chamber walls and centralising stem for correct cleaning seating angle

Versatile disconnect tool for use on a range of Ford / JLR vehicles. Especially on 2.0L Duratec and 2.3L Duratec.

• OEM Equiv: 308-440

This wrench is designed to fit hydraulic cylinders on most farm / construction equipment. Adjustable to fit gland nuts from 2 - 6" dia pin to pin. Also reversible to fit 1/4" and 5/16" dia pinholes.

• Use with 3/4" sq drv ratchet / breaker bar

This wrench is designed to fit hydraulic cylinders on most farm / construction equipment. Adjustable to fit gland nuts from 1 - 3-3/4" dia pin to pin. Also reversible to fit 1/4" and 7/32" pinholes.

• Use with 1/2" sq drv ratchet / breaker bar

Pulls flange-type rear axles on most latest model passenger cars & light truck. Designed to fit axles with bolts & studs up to 5/8" TW10 DA.

Replaces inner tie rods without requiring steering rack removal.

• 30 - 42mm capacity

Versatile on vehicle hand press for front ball joint on common vehicles including Ford AU-BA, Explorer, and Nissan D40 Navara | Pathfinder. Also independent rear suspension bushes on V series Commodore.

• Ford AU-BA11 ball joints - top and bottom
• Ford Explorer ball joints - bottom
• V - Series commodore independent rear suspension bushes