The ET9086 Oil Jug and Measuring Set is a 5-litre, 2-piece set designed for precise fluid measurement and dispensing. Ideal for automotive and workshop use, this set features:

• Clear Plastic Body - Easy-to-read measurement markings for accurate pouring.
• Lids & Handles - Secure lids and ergonomic handles for convenience.
• Flexi Spout - One flexible spout included for controlled dispensing.
• Clip-On Bases - Provides stability during use.

Advanced detector using ultrasonic waves to detect leaks in a range of automotive / industrial applications. Tone generator to check for faulty seals in non pressurised enclosures.

• Detect vacuum / compressed air leaks (down to .13mm)
• Gas turbulence / with air / gas line blockages
• Electrical discharge due to insulation breakdown
• Mechanical wear in bearings, race assemblies etc
• Detect leaks in door seals, vehicle compartments etc

For removing damaged / broken glow plugs (with M8 x 1.0 | M10 x 1.0 threads), especially where they have sheared off under the hex flush with the cylinder head. Includes adaptors for drilling / centring / pulling.

• We recommend that the cylinder head is removed before attempting to remove damaged glow plugs.
• The cylinder head can be left in place. However, if this is to be done, the relevant injector should be removed, and an airline connected using a suitable adaptor to ensure that no contamination (metal shavings, dirt etc) cannot enter the combustion chamber.

A specialised glow plug adaptor for use with testing compression on Nissan ZD30 engines.

• Application: Nissan ZD30 engines
• M10 x 1.25 thread adaptor
• 21cm length

This kit is designed to ream out and clean the bore of the glow plug aperture and the sealing seat, after removing the old glow plug and before fitting a new glow plug.

The kit includes 3 reamers, and 4 glow plug adaptors.

• For M8 | M10 | M12 threaded glow plugs (guide sizes: M8 x 1.0 | M10 x 1.0 | M10 x 1.25 | M12 x 1.25)

Specialised pliers for reaching glow plugs, especially on the latest engines fitted to Audi | BMW | Mercedes | VW.

These pliers are angled at 90 degrees for improved access.

• Soft grip handles.

Pressure Sensor glow plugs should be mounted using protective caps in order to avoid damaging the plug-in connection from pollution / electrostatic charging

• 1/4" Sq Drv x 12mm socket
• Applications: Audi | VW | GM

These pneumatic adaptors are designed to screw into glow plug bores, and fill the combustion chamber with compressed air.

This is necessary when removing / installing valve springs on installed cylinder heads, or for pressure loss diagnosis.

• Sizes: M8 x 1.0 | M10 x 1.0 | M10 x 1.25
• 3 Pce set