This advanced system tester is designed to test all 12V auto batteries (lead, AGM, EFB, GEL etc) including stop / start batteries. The unit tests battery condition PLUS charging (alternator) and starter (crank) systems.

The battery test analyses battery health status to calculate actual cold cranking capability of the battery. The tester will advise whether the battery needs replacing, and is also able to identify a faulty battery before actual failure.

The cranking test analyses the starting circuit (including the starter motor) by measuring increases in starting torque load. The charging test analyses the charging system, detecting under or overcharging.

• Testing range: 100 - 2,000CCA
• Powered from vehicle's 12V battery | no internal battery required

Adjustable jaws fit all hexagon (49 - 135mm) & octagon (49 - 143mm) wheel bearing lock nuts. Contains three sets of pins, applicable to any pin holes on the nut.

• 6 Point lock nuts: 1-3/4" - 5-3/4" (49 - 135mm)
• 8 Point lock nuts: 1-3/4" - 5-5/8" (49 - 143mm)
• Pin diameters: 1/4" | 5/16" | 3/8"

This specialised tool locks the drive flange to prevent rotation when servicing the inner drive shaft mounting bolts / hub nuts.

The specially designed plastic wheels wedge between the brake caliper and the drive flange, using the vehicle's own wheel bolts or nuts.

• Allows easy removal of driveshaft / hub fixings.

• One person operation.

A specialised kit for servicing Gen II wheel hubs / bearings on Ford | Volvo vehicles with 78mm diameter front wheel bearings. These tools ensure that the insertion loads are taken only on the outer race of the bearing. Gen II wheel bearings are a wheel bearing / drive flange that cannot be separated.

Always adequately lubricate threaded force screws and thrust bearings.

• 78mm dia front bearings
• Applications: Ford: Focus II (LS / LT) | C-Max, Mazda: 3 (BK / BL), Volvo: C30 | C70 | S40 | V50

An essential time saving service kit for working on Transit (>06) wheel bearings and brakes on the front axle. Permits correct dismantling of the wheel bearing, with hub and brake disc.

Ford Transits (from 2006) have a design whereby the brake disc is positioned behind the wheel hub. Accordingly every brake disc changes requires the wheel bearing housing with wheel hub to be first removed.

• Removal of wheel bearing housing with hub
• Changing of brake disc
• Changing of wheel bearings
• Removal of the bearing inner race from hub

A specialised kit for servicing Gen II wheel hubs / bearings on Ford vehicles with 82mm diameter front wheel bearings. These tools ensure that the insertion loads are taken only on the outer race of the bearing. Gen II wheel bearings are a wheel bearing / drive flange that cannot be separated.

Always adequately lubricate threaded force screws and thrust bearings.

• 82mm diameter

Special socket for adjusting castellated axle lock nuts on Transit vehicles (80 | 100 | 115 | 120) with RWD type 34 axles.

• 63mm OD | 53mm ID
• 4 Pin design
• 1/2" Sq Drv