Save time - flush out old grease with new. For bearings up to 3-1/2" OD. No airline or grease gun required.

Simply place the bearing on the piston. Press down on the cap until the old grease is forced out, and the new grease shows on top of the bearing.

• Works on bearings up to 3-1/2" OD (90mm)
• Packs up to 50 bearings before needing refilling

Specialty socket which is slightly undersized to avoid damage when removing sump plugs / gear boxes on selected VAG vehicles.

• Type: Spline (Sec)
• Size: M16
• Length: 60mm
• Drive: 1/2" Sq Drv

A specialised Spline (Sec) socket for working on rear hubs on VW Golf | Jetta and other Mark IV chassis vehicles.

• M18 Spline (Sec)
• 78mm overall length
• 1/2" Sq Drv

Impact grade spline socket set covering popular sizes for VAG Group vehicles. Sockets are 1/2" Sq Drv by 78mm long.

• M12 (Rear hub nuts on Touran)
• M14 (Rear hub nuts on Transporter)
• M16S (Rear hub nuts on Sharan)
• M18S (Rear hub nuts on Golf)

This specialised spline security socket is required when working on rear hubs of VW Golf | Seat Leon vehicles.

• M18S Spline security
• 3/4" Sq Drv

A specialised spline bit socket for use on ball joints on VW LT | Transporter | Touran, and rear caliper bolts on VW Passat and Audi A3. Part of the Endeavour Tools range of specialised bit sockets.

• M14 Spline bit socket
• 100mm overall length
• 1/2" Sq Drv

A specialised spline bit socket for removing the bolts that connect the driveshaft to the gearbox, on VAG vehicles.

• M7 Spline bit socket
• 1/2" Sq Drv
• 55mm overall length