Oxygen Sensors

Cut out in socket allows the wires to the sensors to be bypassed. Wire range of applications including Holden, Mitsubishi, Nissan and VAG vehicles.

• 7/8" (22mm) dia | 7mm slot
• 80mm OL
• 3/8" Sq Drv

This thread chaser is designed to clean and repair damaged oxygen sensor port threads.

This thread chaser can also be used on 12mm spark plugs. Always use ANTI-SEIZE.

• M12 x 1.25 thread

This thread chaser is designed to clean and repair damaged oxygen sensor port threads.

This thread chaser can also be used on 18mm spark plugs. Always use ANTI-SEIZE.

• M18 x 1.50 thread
• Use with 21mm socket or 3/8" Sq Drv

Specialised socket with slot that allows the sensor wires to be bypassed. Applications include Holden, Mitsubishi, Nissan and VAG group vehicles.

For heated and non heated Lambda sensors.

• 22mm dia
• 90mm overall length
• 3/8" Sq Drv

A specialised Lambda socket for shrouded sensors on Ford Fiesta 1.2L (08 - 16). Thin wall design / cut out slot allow access to the sensor which is otherwise difficult to access due to the tight fitting heat shield.

• Thin wall
• 22mm x 119mm
• 1/2" Sq Drv

Suitable for oxygen sensors found on most modern vehicles. The sockets have cut-outs and slots to enable the sockets to be fitted over the wiring harness. Includes two chasers for cleaning and repairing damaged threads.

• Thread chasers: M12 x 1.25 | M18 x 1.50
• Oxygen sensor sockets: Straight 1/2" Drv x 78mm L x 22mm | Offset 3/8" Drv x 31mm H x 22mm | 1/2" Drv x 50mm H x 22mm

Swivel head / double ended for greater flexibility on most Oxygen sensors.

Double ended - with BOTH single & bi-hex profile.

• 22mm diameter
• Flexible handle

A comprehensive master kit for Titania and Zirconia sockets.

These sockets are designed for removing oxygen sensors, oil pressure sending units and vacuum switches. Special windows / slots in the sockets allow for removal of sensors without interfering with the wiring harness.