This magnetised bit holder holds standard 1/4" hex insert bits. Features a soft grip rubber handle for comfortable use.

• Holds 1/4" hex drive insert bits
• Blade length: 100mm | Overall length: 205mm

Ideal for cordless drills/ impact drivers. Combined 1/4" hex bit holder and socket driver.

Ideal for cordless drills/ impact drivers. Combined 1/4" hex bit holder and socket driver.

• Combined 1/4" hex bit holder | 3/8" Sq Drv adaptor
• 1/4" hex drive suits impact drivers etc
• 65mm overall length

A handy chrome bit holder for use with 1/4" Sq Drv ratchets. This bit holder has a 1/4" Sq Drv and holds 1/4" hex insert bits.

• 1/4" Sq Drv 
• Holds standard 1/4" hex insert bits
• Ball holds insert bits securely

The Sunflag JL-150 is a premium 150mm long bit holder designed to extend your reach in narrow, hard-to-access areas.

• Ideal accessory for use with power tools
• Suits standard 1/4" hex insert bits
• 150mm overall length

The Sunflag JL-3000 is a premium 300mm long bit holder designed to extend your reach in narrow, hard-to-access areas.

• Ideal accessory for use with power tools
• Suits standard 1/4" hex insert bits
• 300mm overall length

A specialised master kit of pattern style wheel nut sockets. These are commonly used on late model VW vehicles. Socket sizes are labelled to correspond with OEM sizing. From #521 - #540. A similar kit is available with spline style sockets for older VW vehicles.

Do not use with an impact wrench.

• 20 Pce kit
• Pattern style
• OEM Equiv: T10313

This combination wedge tool is designed for lifting bezel edges without marring interior surfaces, and for removing molded body trim pieces without damaging paint.

Also suitable for removing metal clips / plastic fasteners. Also for door, fender, hood and lid alignment. Made from high quality nylon.

• Made from high quality non-marring nylon.

This spark plug hole thread chaser makes it easy to remove carbon, dirt, or straighten damaged threads in spark plug holes. Use with a deep socket, open end or box wrench.

• Tapered double ended design
• 10 x 14mm with 5/8Ò (16mm) hex

Designed to gain access for removal and replacement of the shift selector shaft seal on Holden rear wheel drive transmission. Works with transmission that have the neutral safety switch around the transmission shift selector which requires a longer tool to remove and replace the seal.

• Applications: TH180 / TH350 / TH400 / TH700 / 4L30E / 4L60E to 1995 / POWERGLIDE
• 5/8" drive size | 3/8-16 UNC-2B thread
• Remover bolt has a 9/16" head | 3/8-16 UNC 2A thread.